7-2
www.vibrationmounts.com Phone: 516.328.3662 Fax: 516.328.3365
Finger-Flex Mounts
TYPICAL INSTALLATION ARRANGEMENTS
Any number of Finger-Flex mounts
can be installed in parallel to achieve
greater load-carrying capacity. These
mounts may also be stacked in series
to meet greater deflection requirements.
Separators between mounts, if used,
must be designed to meet the specific
requirements of the installation.
Multiple Installations
Finger-Flex mounts are used for
office machines, electronic equipment,
motors, air conditioning equipment,
heating equipment, fans, blowers,
pumps and scientific equipment.
Typical Installations
Rubber parts used are similiar to
type V10R 4-1504 & V10R 4-1505
combination. The difference is that the
flange of the rubber bushing within this
assembled mounting has fingers on
only one of its surfaces. The ring
member absorbs both vibration and
shock.
A.
If the load support is
1/2 inch (12.7 mm)
or more thick, two
Finger-Flex bushings are
generally used.
B.
When the load
supporting member is
1/8 inch (3.18 mm) to
1/2 inch (12.7 mm) thick,
the standard bushing
and ring combination is
most suitable.
C.
If the load supporting
member is less than
1/8 inch (3.18 mm) thick,
the metal surrounding the
mounting hole should be
turned up. This provides
additional mounting area
for the bushing.
Shoulder bolt
Mounting base
Finger-Flex bushing
Mounting support
Rebound plate
Finger-Flex bushing
Shoulder bolt
Mounting base
Finger-Flex bushing
Mounting support
Rebound plate
Finger-Flex bushing
Shoulder bolt
Mounting base
Finger-Flex bushing
Mounting support
Rebound plate
Finger-Flex bushing
