Finger-Flex Isolators
New Low Cost Vibration Mounts From AAC Feature Unique "Finger-Flex" Ring and Bushing Isolators To Reduce Vibration Transmission In Light To Medium Rotating Or Reciprocating Equipment
The new V10Z 4 Series of low cost,
"off-the-shelf", vibration mounts from Advanced
Antivibration Components feature unique "Finger-Flex"
isolators which are designed for loads up to 37 pounds per mount.
Typical applications for these compactly constructed units include
office machines, electronic and scientific equipment, fans blowers,
heating and air conditioning equipment, motors and pumps.
The natural rubber
"Finger-Flex" ring and bushing in each mount have radial
fingers on top and bottom surfaces to absorb vibration parallel to
the axis of the mounting. The bushings also have axially orientated
fingers which enable the mounting to absorb vibration perpendicular
to the axis of the mounting. To obtain optimum isolation efficiency
there are two hardnesses of V10Z 4 Series Finger-Flex Mounts
available: 30 and 60 durometer. The natural frequencies of the V10Z
4 Series mounts range from 6 to 30 Hz.
"Finger-Flex" washers can
be stacked in series and will yield an assembly with greater
deflection. Any number of "Finger-Flex" mountings can be
installed in parallel to achieve greater load carrying capacity.
Other features of the V10Z 4 Series
include their corrosion resistant zinc plated housing and low
1-1/8", free standing, height. The 2-3/8" square base
dimension and 4-hole tie-down pattern conform to MIL-Size 2. The
load is supported by the top surface of the housing which has a
17/64" clearance hole in its center to accommodate a locating
stud. |
